How to Operate and Maintain Grinding Plant Better?

Posted in Uncategorized - Written by Doris on June 7, 2014

Grinding mills is for common milling equipment, mainly for the barite, calcite, potassium feldspar, talc, marble, limestone, dolomite, fluorite, lime, activated clay, activated carbon, bentonite, kaolin, cement, phosphate rock, gypsum, glass, thermal insulation materials such as mohs hardness is not greater than 9.3, and the humidity below 6% of non flammable and explosive mines, chemical industry, construction and other industries more than 280 kinds of materials of high fine powder processing. But do you know how to operate and maintain the grinding plant?

1, in use process of grinding plant, should be fixed personnel responsible for the supervision, the operator must have a certain technical level. Raymond mill before installation must make the necessary technical training to operators, to understand the principle of grinding mills performance, familiar with the operation procedures.

2, to make the grinding mills are normal, should be developed equipment ‘Raymond mill equipment maintenance security operating system’ in order to ensure the safe operation of the mill for a long time, at the same time to have the necessary maintenance tools and grease and the corresponding accessories.

3, grinding mills should be done after a period of time, use maintenance, as well as the roller shovel knife of ring replacement/repair parts processing, such as roller device is in use for connecting bolt and nut should be examined before and after, to see whether there is loose phenomenon, lubricating oils are added.

4, roller device used for more than 500 hours to replace the roller, the roller set inside of the rolling bearing must be clean, the damaged parts should be replaced in a timely manner, refueling tools available manual pumps and grease gun.

5, Raymond mill fineness regulation, according to the size of the material, hardness and softness, water content, specific gravity, processing the thickness is different, can be adjusted at the top of the analyzer, high speed, high fineness, low speed, low fineness.Improve fineness, production will be reduced, if still can not meet the requirements should debug fan speed, when the user can be flexible.

6, scrapping limit of roller mill ring, minimum residual wall thickness shall not be less than 10 mm.

If you have any other question or have an interest on our product ,you can write to us: info@sinoftm.com.

ultrafine mill: http://www.fte-china.com/pro/superfine_mill.html

Product Specials